MSRM US754 WiFi Extender Setup

The MSRM US754 WiFi extender setup has an easy-to-follow process. Make sure the extender is first plugged into an electrical socket that is linked to the WiFi network you are currently using. When the light indicates that the device is powered on, wait for it to stabilise. Next, use a computer or smartphone to establish a network connection with the extender. Enter the default IP address listed in the handbook to access the setup interface using a web browser. To choose and establish a connection to your home WiFi network, adhere to the on-screen directions. After connecting, you can move the extender to a better spot to increase the range of your WiFi.

MSRM US754 Extender Setup-Manual Guide

1. Apply power to the MSRM US754 Extender by connecting it.
2. Link your device to the network of the extender.
3. Open a web browser and type the IP address listed as default in the manual.
4. To enter the setup wizard, follow the instructions displayed on the screen.
5. After choosing your home WiFi network, type the password in.
6. Await the extender’s connection to be established.
7. After connecting, move the extender to get the best WiFi coverage.

MSRM US754 WiFi Range Extender Setup-WPS Guide

1. Close to your router, plug in the MSRM US754 Extender.
2. The WPS button on the extender should be pressed.
3. Press the WPS button for two minutes.
4. Watch for the WPS light on the extender to show that the connection was successful.
5. If necessary, move the extender to provide better coverage.
6. Enjoy increased WiFi coverage without changing any settings.

NOTE :Call an expert or go to the official website if you need help with your Wavelink wifi range extender. AP.SETUP

MSRM US754 Login Steps 

1. Link the device to the WiFi network of the MSRM US754 Extender.
2. Run a web browser.
3. In the address bar, type ap.setup or “192.168.0.1.”
4. Input your default username and password here.
5. To log in, press Enter.
6. Now that you’re signed in, you can change the settings of your extender as necessary.

MSRM US754 WiFi Extender Firmware Update

1. Connect your device to the WiFi network of the MSRM US754 Extender.
2. Use a web browser.
3. In the address bar, type ap extender setup or  “192.168.0.1.”
4. Enter your password and username to log in.
5. Find the settings menu’s “Firmware Update” section.
6. To download and install the most current firmware update, follow the on-screen steps.

Reset Process MSRM US754 Extender

1. Find the MSRM US754 Extender’s reset button.
2. Hold down the reset button for approximately ten seconds.
3. When the extender’s lights begin to blink, release the reset button.
4. Check for the reboot and factory reset of the extender.
5. Change the settings on your extender as required.